Brewtools Steam Condenser

Out of Stock

The Brewtools Steam Condenser fits the steam hat and uses cold water to cool the steam until it becomes a liquid that runs out of the condenser to a bucket or directly to the drain. The unit is an excellent alternative to a ventilation system. The unit ships with a nozzle that supplies 1.1 litres of water per minute at 4 bar pressure. We also offer other nozzles that offers higher or lower flow depending on the water pressure where the system is used and other factors (sold separately).

Included in the box:
- TC 4" to TC 2" adapter (1 pcs)
- 20cm straight TC 2" pipe (2 pcs)
- TC 2" Tee (1 pcs)
- TC 2" Elbow (1 pcs)
- TC 2" 1/8" nozzle adapter with TC34mm input (1 pcs)
- TC 2" to 19mm hose barb adapter (1 pcs)
- TC 2" Clamp (6 pcs)
- TC 2" Gasket (6 pcs)
- 1/8" BSP-T nozzle, 30 degrees, 1.1 liters per minute @ 4 bar (1 pcs)

You also need:
- Steam hat for your system
- TC 4" Clamp and gasket
- Water inlet adapter (TC34mm to hose or garden connector etc)
- Outlet tube (16x25mm)
- A TC34mm elbow is recommended for the water inlet

Please take note that you need much less power to keep the boil going with this device, and the risk of the wort boiling over is high when too much power is used, so make sure to take the necessary precautions. To sustain the vacuum, the drain tube from the condenser must not have any counter-pressure. We recommend draining to a bucket where the tube is not submerged in the water, or suspend the tube directly over a floor drain.

From: Brewtools, Norway

By Kiwis, For Kiwis

Brewshop is proudly New Zealand owned and operated.

10 Years of excellence

Serving the best home brew beer supplies since 2010.

Partners in craft

Supplying brewery equipment from 5 to 50,000 litres.

Fast, Fair Shipping

Simple flat fees, quick dispatch, and secure tracked deliveries.